PRODUCT DESCRIPTION All new B&D Control-A-Door openers now feature unique Tri-Tran multi frequency operation. Tri-Tran has an automatic frequency change function, with each of its three frequencies transmitted having a much tighter bandwidth. The frequency changes every 22mS during a transmission and reception. So if there is another signal interfering on a part of this frequency spectrum, the automatic change ensures the signal still reaches the opener. This makes Tri-Tran up to one thousand times better, in terms of in band interference rejection, than a typical FM receiver, and up to a million times better than some AM receivers. PRODUCT SPECIFICATION Like: RMDB02 Number of Buttons: 4 Battery: CR2032 Colour: Red Body & Black Buttons Compatibility: TB5v2 (Remote) TB6 (Remote) RDO-1V3 RAP (Roll-A-Pro) RDO-1V4 PD SDO-4V1 (PanelPro) SDO-2V2 ADV SDO-2V2 PD SDO-2V3 PGY (Prodigy) SDO-3V2 CADS (Controll-A-Door S) SDO-3V2 WE CAD S SDO-6 (Secure) SDO-7 (Smart) Remote Programming Procedure Programming New Remote to Receiver Press and hold SW1 (for channel 1) or SW2 (for channel 2) on the receiver board (garage door motor). The LED D1 will start to flash. Press the remote button you would like to use to control the device for two seconds. The LED will start to flash faster. Release the remote button and pause for two seconds. Press the same button again for two seconds. The LED will stay on for a second and then turn off. Release SW button. Deleting a Single Remote from Receiver Press and hold SW1 (for channel 1) or SW2 (for channel 2) on the receiver board (garage door motor.) The LED D1 will start to flash. Press the transmitter button you would like to remove from receivers’ memory for two seconds. The LED will start to flash faster. Release the transmitter button and pause for two seconds. Press the same button again for two seconds. The LED will slowly flash two times. Release SW button. Deleting All Remotes from Receiver Turn the power off to the receiver (garage door motor.). Press and hold SW1 button. While holding SW1 turn power on again. After 15 seconds the Coding LED will light up to indicate that the receiver’s memory has been cleared. Release SW1. All the stored codes should now be deleted.
