PRODUCT DESCRIPTION ATA PTX6 remote Controls up to four garage doors or gates Compatible with PTX2v2, PTX5-P, MC100AML, PTX6, PTX5, PTX2, WTX4-V2, PTX5-D Security: Trio 128 transmitters on 3 different frequencies, Trillions of different possible codes PRODUCT SPECIFICATION Number of Buttons: 4 Battery: CR2032 Colour: Grey Compatibility: DCB-05 (Dual Gate Controller) GDO-6 (EasyRoller) GDO-6v3 (EasyRoller) GDO-6v4 (EasyRoller) GDO-7v2 (SecuraLift) GDO-7v3 (SecuraLift) GDO-8v3 ASM (Shed Master) GDO-9 (Dynamo) GDO-9 (Enduro) GDO-9v2S2 GDO-9v2 (SecuraLift) GDO-9v2 (Enduro) GDO-9v3 (Dominator) GDO-9v3 (Dynamo) GDO-10v1 (Toro) GDO-11v1 GDO-11v3 NES-24v1 (NeoSlider) RD-20V1 SGO-1 (Elite) Program Remote to Receiver Press and hold the blue ‘Door Code’ button on the garage door opener or ‘SW1’ or ‘SW2’ on the receiver board. On the new remote, press the button you would like to use for 2 seconds. Release the remote button and wait for 2 seconds. Press the same button again for 2 seconds. Release the ‘Door Code’ or ‘SW’ button’. Program Existing Remote to New Remote Take any existing remote. Press the button which functions the garage door motor and release after activation. On the existing remote, insert a small needle onto ‘Coding Hole’, press and hold firmly for 2 seconds. Within 10 seconds, press and hold the button you would like to use on the new remote for 2 seconds. Release the remote button and wait for 2 seconds. Press the same button again for 2 seconds. Deleting All Remotes from Receiver Turn off the receiver (garage door motor.) Press and hold the blue ‘Door Code’ button on the garage door opener or ‘SW1’ on the receiver board. Turn on the power again, while holding the button. A coding LED will light up.
